Evaluating TOPAS for the calculation of backscatter factors for low energy x-ray beams
Abstract
For low x-ray energies, backscatter is an important parameter for determining the absorbed dose, making accurate knowledge of backscatter factors (BSFs) essential. BSFs can be difficult to measure experimentally so published values are often derived using Monte Carlo methods. This study evaluated the Monte Carlo code TOPAS as a tool for dose calculations for kilovoltage x-rays, and for calculating BSFs for energies ranging from 50 to 280 kVp. BSFs were also measured experimentally for comparison using Gafchromic EBT3 film and optically stimulated luminescence dosimeters (OSLs). The BSFs calculated using TOPAS were found to be consistent within 2% of the values published in the AAPM TG-61 protocol. The TOPAS BSF calculations were also found to be consistent with film measurements, typically within 2%. The largest discrepancy measured was 5% for the 3 cm field size and 180 kVp beam. OSLs were found to overestimate BSFs for large field sizes and high energies so were found to be unsuitable for BSF measurements with differences of up to 18%.
Read the paper
Related studies
- Characterization and Analysis of Porosity and Pore Structures
- Practical considerations for conducting ecotoxicity test methods with manufactured nanomaterials: what have we learnt so far?
- Dental Optical Coherence Tomography
- Radiation-shielding concrete: A review of materials, performance, and the impact of radiation on concrete properties
- Testing entanglement of annihilation photons
- Calanus finmarchicus seasonal cycle and diapause in relation to gene expression, physiology, and endogenous clocks
Go deeper in Evidence Hub
Evidence Hub adds a study data sheet (design, sample size, evidence level, key numbers), an AI summary and a chat grounded in the paper's text.