Effects of water and melt on seismic velocities and their application to characterization of seismic reflectors
Abstract
The effects of a silicate melt and water on seismic velocities are compared at relatively small fluid fraction (less than 20 vol.%) on the basis of a theoretical model of composite materials, to show that the two fluids are clearly characterized by the velocity ratio Vp/Vs. For a silicate melt, Vp/Vs increases with increasing fluid fraction. When a significant reflection is expected, Vp/Vs becomes much larger than 2. For water, Vp/Vs decreases as the fluid fraction increases to 10 vol.% then it increases. But it remains similar to a solid state value (about 1.8), unless the amount of water exceeds 15 vol.%. This will be a good measure to distinguish between two candidates for seismic reflectors: partially molten rocks and rocks containing free water. If a reflector can be treated as a thin low velocity layer, the velocity ratio in it can be estimated from the frequency dependence of reflection coefficient.
Read the paper
Related studies
- Current state and future directions for deep learning based automatic seismic fault interpretation: A systematic review
- Physics of Partially Saturated Porous Media: Residual Saturation and Seismic-Wave Propagation
- Modern Imaging Using Seismic Reflection Data
- Effects of marine seismic surveys on free-ranging fauna: a systematic literature review
- A review of the recent seismic activity in the southern part of egypt (upper egypt)
- A review of research on mechanism of seismic attenuation and energy compensation
Go deeper in Evidence Hub
Evidence Hub adds a study data sheet (design, sample size, evidence level, key numbers), an AI summary and a chat grounded in the paper's text.